All times are UTC


It is currently Tue Apr 30, 2024 4:32 am



Post new topic Reply to topic  [ 8 posts ] 
Author Message
 Post subject: Strength Zero.... what does it mean?
PostPosted: Fri Jun 11, 2010 6:15 pm 
Wayfarer
Wayfarer
Offline

Joined: Tue Jun 08, 2010 10:19 am
Posts: 16
Location: Canada
Hello fellow Gamers,

Last night while playing a 1500point WOTR game Angmar vs Elves, I had a spell cast on my archers which dropped my strength from 3 to 0. Yes a six was roled.

Some debate ensued, and after long consultation with the rule book could not find anything offical. Couple of questions that I am looking for answers on.

1. Is strength zero even an option, or is the lowest it can go one?

2. If strength zero is possible, what does it mean for shooting, movement and combat?

Any tips on where I can find answers to these questions would be well appreciated. If this is the wrong forum to ask this question in I apologize in advance.

Steve
Top
  Profile  
Reply with quote  
 Post subject:
PostPosted: Fri Jun 11, 2010 6:20 pm 
Loremaster
Loremaster
User avatar
Offline

Joined: Mon Mar 08, 2010 3:58 pm
Posts: 1332
Location: Ha, wouldn't you like to know.
Images: 4
I'm guessing the lowest it can go is 1, other wise just treat it as if there was one lower than 1 on the to hit table.

_________________
"War does not determine who is right, only who is left."
- Bertrand Russel
Top
  Profile  
Reply with quote  
 Post subject:
PostPosted: Fri Jun 11, 2010 6:49 pm 
Wayfarer
Wayfarer
Offline

Joined: Tue Jun 08, 2010 10:19 am
Posts: 16
Location: Canada
That is what I was thinking, but without a formal rule on it, seems it is just going to have to be one of those agreed to bunker rules.
Top
  Profile  
Reply with quote  
 Post subject:
PostPosted: Fri Jun 11, 2010 7:27 pm 
Kinsman
Kinsman
User avatar
Offline

Joined: Sun Dec 20, 2009 3:03 pm
Posts: 128
as far as I know there is a rule that says no characteristic can go higher then 10 or lower then 1. I think it is at the start of the rulebook where it introduces character profiles
Top
  Profile  
Reply with quote  
 Post subject:
PostPosted: Fri Jun 11, 2010 7:38 pm 
Craftsman
Craftsman
Offline

Joined: Wed Apr 07, 2010 2:44 pm
Posts: 484
Location: London
1. Section of the rules which hardly anybody ever reads/notices, page 29 "Absolute Zero" states that stats can not go below 0. It doesn't stop you from going below 1 however.

2. In the same time, since there is no 0 on the wound chart, I would say it is impossible to wound -> if you had S1 you are able to wound as seen on the chart, with S0 you are not able to wound. For movement you just can't move. For shooting, the 0+ is better than 1+ by 1, for courage it's obvious, others are unaffected.

_________________
Coordinator of the Great British Hobbit League
Top
  Profile  
Reply with quote  
 Post subject:
PostPosted: Sat Jun 12, 2010 8:28 am 
Craftsman
Craftsman
Offline

Joined: Wed Apr 07, 2010 2:44 pm
Posts: 484
Location: London
In fact, I cancel my Strengh 0 response.

Elf Master wrote:
Some debate ensued, and after long consultation with the rule book could not find anything offical. Couple of questions that I am looking for answers on.

I assumed that you looked at Enfeeble rule before posting, so I didn't bother, but I looked just now and you clearly either a) did not consult the rulebook or b) can't read. Page 71, Enfeeble "On a roll of 6, the target instead suffers a -3 penalty to Strength (to a minimum of 1)". End of debate if you read the full rule.

_________________
Coordinator of the Great British Hobbit League
Top
  Profile  
Reply with quote  
 Post subject:
PostPosted: Sat Jun 12, 2010 12:14 pm 
Wayfarer
Wayfarer
Offline

Joined: Tue Jun 08, 2010 10:19 am
Posts: 16
Location: Canada
Thanks Blackmist.... I actually just took my opponents word for the ruling, a big mistake on my part apparently. Thanks for clarifying this one guys.

Steve
Top
  Profile  
Reply with quote  
 Post subject:
PostPosted: Sat Jun 12, 2010 2:29 pm 
Loremaster
Loremaster
User avatar
Offline

Joined: Fri Jan 15, 2010 8:41 pm
Posts: 1279
I had presumed that that was the wording. However, it may be that the reference page was used which may not state to a minimum of one (although I'm too lazy to check).
Top
  Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 8 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 21 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: