Just a quick tip. If you're feeling adventurous, you can add nice furls to your banners using some PVA and water. It doesn't work so well with Inkjet printed banner but colour laserjet prints work fine. Just lay out three or four paint brushes side by side, going from a thick stemmed one to a thin stemmed one. Then dip your banner into a 50/50 PVA/water mix and lay it onto the brushes at the angle you want, then you can poke the banner down into the spaces between the brushes and let it dry. Then your banner will be both tough and shapely

. Sometimes its good to put some cling film under the banner when you lay it down or it might stick to the brush handles or whatever you're using.
Eorling.